Gamesir G7 Pro Cable Retainer

For those that may need a spare Cable Retainer for their Gamesir controller! This was modelled after seeing a few requests for them online. I used the one from my G7 Pro so it will definitely fit your G7 Pro all being well! Check your calibration settings if it doesn't :)

 

Designed as a replica of the original. It has some slight differences but functions as well as the original. I think it actually fits nicer and isn't as tough to slide down but fits well enough it doesn't come out too easily either.

 

13min Print and only 7g of Filament used. Strength has been considered so you don't lose the small clips inside your controller. Please be careful pushing it in and out of the housing! 

 

The Black part in my images is the original piece and is pictured to show as a comparison. I'm not claiming to have printed that one haha! 

Boost MeIf this has saved you scouring the internet for a file and has restored your Gamesir controller back to it's former glory then please leave a boost if you can spare it :) Thanks <3