Light Bulb Desk Lamp

💡 Modern Bulb Desk Lamp

A sleek, modern desk lamp inspired by the shape of a classic light bulb. Designed to bring minimalist style and soft lighting to your workspace, nightstand, or creative setup.

Features:

• Modular design for easy printing and assembly
• Stable tripod-style base

• Works with LED puck sourced from Amazon

  https://www.amazon.com/dp/B0C38X5Z4Y?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1

• No supports needed for most parts.

  The “Large Lightbulb Head” benefitted from supports on the very bottom where it starts curving off the build plate

Recommended Print Settings:

• Layer Height: 0.2 mm
• Infill: 15%
• Material: PLA or PETG

• Build Volume: 200 mm+

   

  Assembly: 

  The wire for the light puck can either be cut and spliced back together or un-soldered from the board and fed through the stand as shown, then soldered or crimped back together. Also, if neither is desired, the end of the wire with the 12V end, will fit through the hole at the bottom of the grey “Light Bulb Lamp Base”  piece, and just not thread through the stand.

            

   

  After the wire is fed through all the components, press the light puck in to the base lining the groove up for the wire, until it bottoms out.

     

   

  Next, Press the green “Light Bulb Lamp Head” in to the top of the grey “Light Bulb Lamp Base”. Its a tight fit and will bottom out on top of the light puck. Check that its seated evenly, then the clear diffuser can be glued on top. Print the diffuser in clear PLA with no infill and solid layers. Also, you can slide the stand “C” piece around the grey bulb base.

   

   

  Lastly, press fit the stand to the “X” base. It can be glued if desired, to make it more stable.

   

  Press-fit for most parts. Only parts i glued were the long vertical part of the stand with the “C” holder piece that holds the lamp assembly together. See picture below