65mm Dust Shoe V2 Genmitsu Router

(Woops, Designer for the Genmitsu 4040 Pro Max)

The first version of this dust shoe was bulky, bad air flow, the brush was non removable and changing bits was a pain. All of those issues have now been solved with this new version.

The New Dust Shoe Features:

• Magnetic brush attachment for easy removal bit changes
• Optional screw in holes that will make sure the brush wont come lose during run time (if you dont have strong magnets)
• Sleek and minimal design
• Space to enlarge the router hole up to 68mm (the bigger the router the less material is on the inside wall for the brush crevasse)
• Space to enlarge the vacuum hole connector from 35mm to 40mm

 Material List:

• 6 M4 15-20mm Screws
• 6 M4 Heat inserts
• Nylon Brush 70mm or 100mm
• 2 Part Epoxy
• 30 5mm Wide 1.9mm/2mm Tall, neodymium magnets

The magnet holes are 5.1mm in diameter and a 2.25mm in depth, when assembling, no glue is required, just a sturdy surface like the flat side of some scissors and some force to push in the magnets into the holes. When pressing the magnets into the “main” model part, i recommend having the bottom surface of the “main” model  which is under the magnet you are installing rested against a flat surface (like an edge of a table, so it wont break from the pushing force. 

The model requires no support when printing due to the pointy top of the horizontal holes. The big holes on the “main” model are to have heat inserts in order to attach the tighteners for the router and vacuum hose. The “brush” model has 2 heat insets in the middle are that are there in case you want to screw it to the “main” piece for guarantied attachment which you can do using a thin screw driver.

(Affiliate Ebay Links) (I get a kick back i you purchase via this link)

Nylon Brush - https://ebay.us/YB6HJH 

2 Part Epoxy - https://ebay.us/MRKCB3 

Magnets - https://ebay.us/Q0cr89 

Screws - https://ebay.us/KwnZJE