MTG Land Type Markers for Multiversal Passage

Multiversal Passage Land Type Counters for Magic: The Gathering

 

I was watching the Baltimore Standard RC and kept seeing people scribbling “Island” or “Mountain” on a piece of paper then putting it on their Multiversal Passage and thought “that sure is inconvenient and sloppy”. So I made these simple little clips that will slide neatly onto a double-sleeved Multiversal Passage, or Valgavoth's Lair, or really any card.

 

Boost MeLike my designs? Consider sending me a boost. They keep me inspired to make more Magic: The Gathering accessories.

Want to sell physical copies of my prints? Subscribe to my Patreon for a commercial license! Go to patreon.com/MTGMatt

 

While they are all on one build plate, it's best to print them separately. Individually they only take about 15 minutes to print, printing all 5 at once takes about 2 hours.

 

Make sure you have supports enabled and on build plate only (it's already on in the print profile, just don't turn it off). Since the initial layer is set to 0.3mm to help with the finer details, you might want to set the heatbed to 65 degrees to help with bed adhesion.