Filament Poop Box/Bucket Holder P2S/P1S/H2x/X1C

♻️Minimal Filament Poop Box Mount – Reuse Your Spool Box!♻️

Added new model geometry to fit the P2S with the added exhaust kit without any interference.

 

I didn’t like that most filament poop holders require a lot of filament to print, so I decided to rethink the design.

 

Designed for the Bambu Lab P2S (with or without exhaust kit), but it also fits P1S and X1C and should now work with H2 series

This model is made to hold a spool box — yes, the same box your filament spool comes in!

It’s a low material, quick-to-print, and smart solution for catching those colorful filament poops during color changes.

To make it work, you’ll need to make a modification to the box: 

cut whole box at 160-170mm height

cut each corner at about 20mm

bend 3 flaps inside

bend the fourth flap outside, this is the part that youre going to slot inside the printed mount

 

The part is printed with supports, but don’t worry — they’re easy to remove. Just slide a thin knife between the support layer and the model, and they’ll come off cleanly.

Keep your printer area tidy without wasting extra plastic!

 

Happy printing

 

Share your thoughts and show off your prints in the comments!

Boost MeI would really appreciate a boost if you liked my model 😉