----2026.3.30 Fixed an overhang on Plate 11 that could occasionally cause print failures, removed the Safe Mode. The test results for the new configuration are as follows. The printer used was an old P1 with 4800 print hours, non-glued plate, PETG HF.
----2026.1.30 Adjust Safe Mode:
Currently, Safe Mode only includes the blade connector of Plate 2 and the body of Plate 11. The old Safe Mode was too time-consuming.
Support structures have been significantly reinforced to resolve issues of supports breaking when using certain printer or filament.
----2025.11.10 Congratulations to Makavelli for being the world's first!
----
The weapon wielded by Tirion Fordring in World of Warcraft —— Ashbringer.
Whole new design for FDM printing based on the in-game look.
The Full Size version is 110cm long, compatible with A1 and above.
The 72% Size version is 79cm long, compatible with A1mini.
The Full Size version of the Silver Hand ball can be fitted with the following kit to achieve flame illumination:
KA009 (30cm LED)
x3
ZH090 (1to2 Adapter)
x1
XC007 (Wires)
x1
ZC003 (Battery Module)
x1
About Print Profile:
All pieces have passed the non-glued plate test.
All profiles are pre-supported and can be printed directly.
There is no significant difference between PETG and PLA, but if you have installed the LED kit, the blade section will be heavier. Therefore, it is recommended to use PETG for the blade.
About Assembly：
See attached assembly guide for installation sequence, no screw or glue needed. However, I suggest to glue the blade section to prevent loosening and detachment during swinging.
About Color:
Color references are preset in all profiles. It is recommended to print directly with metallic PETG.
sarwtin
