KAIWEETS KETS02 Soldering Station (UK PLUG)

This is a remix of https://makerworld.com/en/models/1033459-kaiweets-kets02-soldering-station?from=search#profileId-1016775 to enable the UK style power adapter to be stored in the box. I have also resized the screw on lid to 98% as I found the original was a bit tight.

The rest of the description is from the original designer.

"This project adapts a Thingiverse design, https://www.thingiverse.com/thing:3338826, for my new KAIWEETS KETS02 soldering iron.

PLA+ was used for all parts; it requires five M2 x 12mm screws for the cable door, power supply retainers, soldering iron support, and tip holder; and eight M3 x 20mm screws for hinges and closures.

The tip holder is absent from the photos as it was not yet installed.

The soldering iron support incorporates a sponge to prevent loss, although its placement is flexible.

The solder compartment features a screw-on lid and accommodates approximately three meters of wire, depending on its gauge.

The container closure uses either a single clip or a two-part assembly.

A larger power supply base has been added; precise dimensions were unavailable, but maximum enlargement was prioritized."