Puzzle Tube for gifting cash

⚠️ PLEASE READ BEFORE PRINTING THE FINAL BOSS ADD ON ⚠️
The final boss is add on for the main Puzzle Tube, it is a completely sealed tube as one last twist in the Puzzle Tube.

It's recommended to print with transparent PLA/PETG filament so the recipient can see the money inside but can't quite get their hands on it yet, but could be printed in any filament if you prefer.

There is a small perforation at one end which should allow the top to be broken off to release the money.

PRINTING

There are 2 plates, one for PLA, one for PETG.

There is a pause at layer 381 which will allow you to insert the money before it gets sealed in.

⚠️ Obviously a 230c nozzle and paper or plastic money is not a good mix, so when inserting money please make sure it is pushed as far into the tube as possible so the nozzle will not touch it.

The walls of this part are very thin, so after printing is complete, let it cool completely before removing from the plate.

Bend the plate and/or use a scraper to release from the plate rather than just grabbing it - I broke one is testing by doing this.

⚠️ Maximum note height is approximately 75mm and should fit all USD, AUD and most GBP, EUR and RMB notes 

⚠️ £50, €50 and ¥100 notes will NOT fit. (But they will fit in the main puzzle if you don't use the final boss)

⛔ I TAKE NO RESPONSIBILITY FOR ANY DAMAGED MONEY AS RESULT OF PRINTING OR USING THIS MODEL ⛔

If you don't want to risk real money in the final boss you could add Monopoly money or leave a note inside with instructions to find the real gift