BLTouch Wing with Integrated Cable Tower

This setup combines BLTouch / CR Touch wings with a medium-height cable tower, giving you a clean way to route probe and hotend wiring while keeping everything supported above the carriage. The left and right wings are sized to match the narrow Hero Me Gen7 style mounts and share the same integrated tower geometry, so your wiring and strain relief look consistent on both sides.

Versions included

• Left wing with cable tower
  Narrow BL/CR Touch wing for the left side, with a built-in medium cable tower for probe and toolhead wiring.
• Right wing with cable tower
  Mirrored version for the right side, matching height and routing to the left wing.

Both versions are intended for Hero Me Gen7-style setups and Ender-3 / CR-10 family printers (or similar carriages) using a BLTouch or CR Touch probe.

Features

• Integrated cable tower for cleaner wiring and strain relief
• Left and right wings for symmetrical setups
• Narrow profile to clear ducts, part cooling and belts
• Single-piece prints for each side, no extra hardware beyond your existing probe fasteners

Remix attribution

This model is based on the BLTouch / CR Touch wings and cable tower design by MediaMan3D, originally created for Hero Me Gen7 style setups. I combined and adapted those parts into single left and right wings with an integrated medium cable tower for simpler installation and cleaner wiring.