Owl House – Skadis Mount for Echo Dot Kids

A decorative speaker house designed for the Echo Dot Kids.
Perfect for IKEA Skadis pegboards, kids’ rooms or gaming setups.

✨ Features:

• The speaker sits securely in its base.
• Side openings don’t just look good – they allow sound to pass freely and ensure the microphone isn’t affected during voice commands.
• Integrated cable routing and rear cable storage keep excess wiring clean and hidden.

🧩 Versions:

• Two-Part Model: Base and roof printed separately. They can be glued if desired. Ideal for multi-color results.
• Single-Piece Model: Printed in one go with integrated roof. Simple, sturdy, no assembly required.

➡️ If you want a simple holder without housing or extras, check out my model: IKEA Skadis Holder for Echo Dot Kids

⚠️Important notes:

I performed several print tests to achieve the best results.
The provided profiles delivered the best outcome on my setup – however print quality always depends on the combination of printer, slicer, and filament.

Initially, I encountered a slight layer shift between the base and wall transition (see image below) – this was resolved through tuning.

The following settings played a key role:

• Brim on the base recommended to prevent minor warping
• Reduced print speed for a more stable result

• Flow ratio set to 0.96 (based on my filament: eSUN PLA+) ➡️  please adjust your settings if needed.

Remove supports carefully to avoid damaging the snap-fit hooks.