4-Way PTFE Tube Guide & 90° Corner Adapter

I designed this bracket to route four PTFE tubes (4mm OD) from one orientation, to another and around a 90-degree corner to keep my filament paths clean. To be honest, I designed it for my specific setup, but after printing it, I realised my cabinet is actually too small to fit it properly!

I didn't end up using it, but I’m sharing the file in case it fits your setup better than mine. It’s a solid design for managing AMS/BMCU lines or multiple spools if you have the space.

Print Settings:

• Material: PLA or PETG.
• Orientation: Print on the flat bottom face.
• Supports: None required.
• Screw Size: Edit the model using the customise button to increase or decrease the diameter of the holes.