Slinky-Christmas Tree (No AMS Required)

🎄Slinky Christmas Tree · No AMS Required

For the best printing results, PLA filament is recommended.To make the star decorations on the stumps and treetops more secure, a small amount of glue can be used to enhance adhesion.

If you print with PETG, or if the parts do not fit properly after printing, try adjusting “X-Y Outer Contour Compensation” 

If too tight, adjust it to -0.05 mm.
If too loose, adjust it to 0.05 mm.

⚠️ Important Handling Instructions

After printing, the spring structure will be fused together.
Use a thin blade to gently open a small section of the gap, then carefully pull and separate the spring layers to activate the bouncing spring mechanism.
Handle sharp tools with care.

Please refer to the video below for a detailed demonstration.