ikea skadis mini vacuum holder V2

Boost MeBoost me for free if you like this print. Thank you for your support, it is much appreciated. 

This is Version 2 of my ikea skadis mini vacuum holder (find Version 1 here: Link). It now comes in two variations.

• the regular one for just the vacuum (measurements stayed the same, it only uses less filament, prints faster and holds tighter to the skadis wall).
• the extended version with a holder for a vacuum accessory.

Version 2 comes with some improvements over Version 1:

• it needs less Filament compared to version 1
• the variation without the accessory holder prints faster (the one with the accessory holder prints just slightly longer - about 3 Minutes)
• the fit on the skadis wall is tighter compared to version 1

If you print the version with the accessory holder, please check if your accessory will fit before you print. Mine has the following inner measurements: 27.2mm x 10.2mm with a corner radius of 5 mm. With those measurements my accessory fits perfectly. 

 

The accessory holder was specifically designed for the accessory shown in the picture because thats the one i use all the time. Others might fit, but no guarantee.

 

I still use the following vacuum: Link

 

(no affiliate link - I personally think the vacuum cleaner is very good)

If you like this print profile, I appreciate a like and a 5 star rating, thank you!