Filament spoolholder for dryer support (on 3D printer)

This spool holder is designed for use with the filament dryer support for 3D printers (MK3S+), allowing for simultaneous printing while drying filament or accommodating large spools that won't fit inside the filament dryer.

To use it, simply place it on the designated support in the correct orientation. For printing the spool holder itself, it's recommended to use PLA or PLA+ as these materials make support removal easier.

I've provided two versions of the holder: S and L. The S version shares the same geometry and relative positions as the filament dryer, while the L version allows for the use of either very wide or relatively narrow spools.

Each spool holder requires a different rod length: the S version uses a 95mm long rod, and the L version uses a 114mm long rod.

BOM:

Assembly instructions:

The system is very easy to assemble, but I'll detail it below:

Step 1. Insert the rod into the 2 bearings.

Step 2. Insert the above assembly into the bearing seats.

Step 3. Place the cover over the bearing and secure it using the Parker screws.

Step 4. Place the spoolholder on the diy filament dryer support.

Related models

This model will not be functional unless you have printed both of these:

DIY Dehumidifier for 3D Printer Filaments

Central model:

https://www.printables.com/model/494417-diy-dehumidifier-for-3d-printer-filaments

Filament diy dryer support for 3D printer

For mounting in the Prusa MK3S+ and other printers you can check this model:

https://www.printables.com/model/541556-filament-diy-dryer-support-for-3d-printer