P2S / P1S/ X1C bulit-in toolhead cover holder

******** 2026.01.12 Update ********

I made V2, Which doesn't need magnet, and re-calibration.

please check out below, if you interested :)

P2S bulit-in toolhead cover holder V2

---------------------------------------------------------------------------------------------------------------------------------------------------------------

I created a magnetic toolhead cover holder that attached to the toolhead itself for easy access.

Designed for P2S,
but may work with P/X series.

(they have the same side holes on the toolhead)

It stays with no problem during the use of printer,
and of course, it works perfectly for its original purpose of holding the cover :)

If you use a P/X series printer, you might want to give this a try.
It only requires 1.18g of filament.

1.  You only need two materials:
       - 1.18g of filament
       - 8mm x 3T magnets 4 ea

    

2.  Insert  magnet into each holder's slot.
       (I didn't use superglue. )

    

3. Snap in the pins into the holes as shown below.

    

4.  Attach a magnet to the inside of the cover.
      (This holds the holder more securely and adds magnetic force.)

    

    

    

    

   *** Update on 2025-12-14 ***

I found minor misaligned Nozzle Purge Position problem.

In my case, nozzle is misaligned 2~3 mm left from center.

so I found the solution for this.

the Procedure takes only a few minute,

and completely solve problem.

It doesn't cause any problem during print, but purge.

as shown on photo, when purge, filament from nozzle sits on the wiper.

I had no problem with it yet, but It's better to move it normal position.

Here's the solution.

Bambulab providing Manual calibration for Nozzle Purge Position.

https://wiki.bambulab.com/en/p2s/troubleshooting/purge-wiper-position-calibeation

1. download and run

   Purge offset detection file: purge_pos_test.gcode

2.  measure your offset between the nozzle and groove on the nozzle wiper.

3. run corresponding Calibration file from the package

   Calibration file package: cali.7z

4.  You will need USB flash memory duiring this process.

hope this will help, who need it.

thanks :)