Infinity Serpent - Long Articulated Dragon

Filament used in photos: visit my homepage www.hollowmaker.com

Infinity Serpent is an extra-long, articulated dragon designed to emphasize flowing movement and visual impact. Its extended, serpentine body creates a continuous wave-like pose, making it especially striking when displayed across shelves, desks, or larger surfaces.

The model features sharp, layered scales and pronounced details along the entire spine, giving it a dynamic and almost endless appearance

Important printing note:
This model takes a relatively long time to print and can produce a considerable amount of failed-print waste on some printers if the first layer doesn’t adhere perfectly. To avoid this, make sure your build plate is spotless and ideally use an additional adhesion aid such as 3D-Lac or hairspray — better safe than sorry!

This print profile was created for printing with the H2D/H2C from BambuLab. Print times may vary significantly when using other printers!

• No supports required
• Total length: 127.5 cm / 50 inches
• Clean the print plate with alcohol before printing and avoid touching the print surface with your fingers!

• Use an additional adhesive like hairspray or 3D-Lac if you’re not sure whether it will stick.

   

Filament used in photos: visit my homepage www.hollowmaker.com