Mag Pouch 556. AR15 / M4 (Taco Style)

Mag Pouch556. M4 / AR15 (Taco Style)

Note:

I dont have an m4 mag so I used a 3d printed dummy. After some feedback I can confirm they Fit!

Some of the pictures are from my other model, that is just a different size.

 

3D-Printed Mag Pouch for 556. Magazines

I’ve created a simple and effective solution to store up to three magazines on a plate carrier. The design holds the mags tightly, so you won’t have to worry about them falling out, even during fast reloads or movement.

The  design allows to mount other pouches infront of them with a molle strap (as seen on the Pictures)

🧷 Parts required 

• 4x m4 nut
• 4x m4x12mm countersunk screw
• Rubber band with a 4 mm diameter and a lenght of 80cm ( need to be cut into two equal parts )

🔧 Assembly Instructions:

• Screw in the two molle clips with the Screws and Nuts as seen on the pictures
• The two rubber bands with the lenght of 40cm each needs to be put through the holes as seen on the picture
• When putting the pouch on the plate carrier, do not foregt to put on the molle clip locks!

I hope you enjoy using this mag pouch as much as I do! Don't forget to rate my Model!

Boost MeBoosts are free!! And would support me alot!