Finger Dirt jumper / mini mountain bike

Finger Dirt jumper

Small model of dirt jumper mountain bike , perfectly scaled for fingers.

made to be as strong and have minimal play in headset as possible.

this finger bike is perfect for tricks like tailwhips and even barspins if you are advanced,

its super simple and made for use and not only sitting on shelf.

it should not need glue but if something is too loose you should use it 

and you might need to use a drill or something sharp to make the holes bigger

the model was inspired by NS bikes decade v2. i hope you will like because i spent almost a year making it as good as possible,

assembly guide

• you need filament for locking stem to a fork

   

  -  use the 3d printed pins to lock the wheels to fork and frame (there are 2 sizes in bambu studio so try both to see which one fits better) 

   

  - insert the seat into the frame you might need to use some force

   

  - insert the crank with cylinder into the frame and press the other crank in

   

  -insert the fork and add spacer 

   

  - press the bars onto the forks like on image and insert a piece of filament (1,75mm)

  into the hole you might need to make the hole bigger or use a lighter to make the filament smaller

   

  - finally press the grips onto the bars

   

  thanks for downloading and let me know if everything fits

Boost Meif you like my models, help me get a new 3d printer

 

• also if you like this model you should check out my finger bmx and other models