Apple Vision - "Dual Solo" band adapter/clip

These clips allow you to attached a second Apple Solo Knit band for the top of your head. It makes wearing the Apple Vision Pro dramatically more comfortable, and adjusting the bands is a breeze with the knob!

You are solely responsible for any damage you may cause to your band. Make sure your print is clean, otherwise you may scratch the silicon band near the earphones.

Due to the nature of the small clip attachment, you need to print this in high resolution, 0.10mm recommended for best results.
To install, remove the current band from your Apple Vision Pro. Slide one clip on each side, until it stops. Do NOT force into place.
Clip the back-of-head solo band back into place.
Now clip the top-of-head solo band onto the clips, they should clip into place.

DO NOT Carry your Apple Vision Pro from the top band! Always use two hands to carry.
Your print quality will vary depending on your printer.
I recommend a small size solo knit band for the top. If you find that you're unable to fully tighten it, it's likely that the top band is sitting too far forward. Loosen it, then move it back toward the top of your head.
The clips are designed to be reversible! If the band is still too loose on your head, flip one or both clips upside down, then clip the band on.

Print Settings:

• Supports:

No

• Resolution:

0.10

• Infill:

20%