Retro Bills Standing Buffalo

This is a model of the Buffalo Bills standing buffalo without an insert for a chain.  It should look great on your desk or even hanging on a wall using a good adhesive tape.

 

I do intend to make a stand that will allow the Buffalo to not fall over as easily in the near future.

 

It is approx 232x172.8x13.   It takes approximately 2 Hours and 10 minutes  and uses 109 grams of filament.  68 White and 41Red.

 

Boost MeFeel free to leave a Boost if you feel so inclined.  Thanks for downloading and hope you enjoy!