Keep your spare hotends organized right inside your printer. This mount leverages the internal magnets of genuine Bambu Lab hotends, providing a secure snap-fit when docked.
Key Features
Magnetic Synergy: Specifically designed to align with the hotend's internal magnets for a secure hold.
Zero-Hardware (Center): The existing chassis screw serves as the magnetic anchor for the center slot.
Standard Spec: Designed for screws in the side slots to enable full magnetic docking (friction-fit works without screws, but they are recommended for maximum stability).
Universal Fit: Compatible with 0.2mm, 0.4mm, 0.6mm, and 0.8mm genuine hotends.
Installation Guide
Preparation: Drive a small self-tapping screw (max 5mm length) into each slot except for the center one. These screws will serve as the magnetic catch plates.
Mount: Remove the existing screw from the left side of the P2S internal frame. Align the holder's center slot and install it using that same screw.
Dock: Slide your hotends in and push them all the way to the back. You will feel the magnetic lock engage.
Print Recommendations
Material:PETG / ABS
Note: Use dry filament to ensure precise tolerances for the magnetic alignment.
⚠️ Safety
Collision Risk: If the hotend is not pushed fully to the back of the slot, it may collide with the print head.
Check: Always visually confirm that all nozzles are fully seated before starting a print.
Disclaimer: Use at your own risk. The designer is not responsible for any damage or accidents resulting from the use of this mount.
Nanashi
