Beta Meshtastic RAK 19007 duel 18650 no tools

This is a V2 of the beta model - so use at your own risk, of a weather resistant mesh node enclosure for RAK 19007 and duel 18650 batteries. Use an N-Type to ipex antenna connecter with an N-Type antenna - works great with the RAK Meshtastic Starter Kit. You must use self amalgamating tape around the antenna base, and where it joins to the case, and may need to use a flat head screwdriver to get it to take to the seal lip.  Solar passthrough models available as well, with a TPU plug if you print the solar model but don't need it yet. TPU gasket to be added to the chassis (lid) - case works fine without, but not necessarily as water resistant. Learn more about meshtastic here: https://meshtastic.org - there are different print plates/models, for both  868mhz and one for 915Mhz labeling each with or without solar pass through. There is a designed space for GPS module, but this hasn't been fully tested (likely case is too think to work properly) - and the batter drain defeats the purpose of this build. As long as good bridging capability, this can be printed without supports, there are two removeable supports desiged into the chassis model to save on slicers wasting fillament. Constructive feedback actively encouraged in the comments below - Step files also available for down load for personal use modification. Documentation to follow - but should be fairly self explainatory.