Highlander Connor MacLeod Katana Sword Inspired

⚠️ Important Notice Before Leaving a Negative Rating!

To ensure a solid and durable assembly, this model relies on very precise tolerances.
Because of that, your printer must be well calibrated and your filament must be dry.
If these conditions are not met, parts may feel too tight or difficult to assemble. This is intentional for stability and not a design flaw.

Printing conditions: 3mf file / Bambu Studio Slicer / Bambu Lab H1C / stl not recommended!

***

This model is inspired by the katana sword used by Connor MacLeod in the movie Highlander.
It is designed to be easy to print and consists of parts that are assembled by press-fit — no glue required.

With proper calibration, the result is a sturdy, clean-looking katana sword that holds together very well.

Enjoy printing — there can be only one! ⚔️

Assembly Notes

• All parts are designed to be pushed together.
• If the two rivets cannot be pressed in by hand, you can carefully widen the holes using an 8.5 mm drill bit.
• If hand pressure is not sufficient, use a rubber mallet and gently tap the parts together.
• Do not use excessive force.

Additional Assembly Tip

If fitting the parts together feels too tight, I recommend lightly chamfering the edges with a utility knife (box cutter).
Removing just a small amount of material from the edges can make assembly much easier while maintaining a secure fit.

***

Download suitable katana stand or wall mount