P1S Stock Replacement Foot (PETG - NOT TPU)!

Same as most of my models, I couldn't find exactly what I needed so I created it myself. The other models I found were for TPU or some other ‘special’ type of foot. In my experience, there's no need for anything special as my prints still come out great. 

I purchased my P1S second hand and it was missing one of the feet. That's the whole backstory. 

This is a replacement for the stock rubber foot of the P1S that you should print in PETG. It is slightly shorter than the original one to account for the ‘squish’ in the original feet. This is done in case you are like me and only replacing one foot, not all 4.

The fitment is tight and requires no adhesive or extra work. The base is smooth to reduce scratching on the surface you place your printer on and to make it a bit easier to slide out if necessary. 

NOTE! - If you are replacing all 4 feet, please consider adding some sort of rubber or grip to the feet or it may be less stable.