Milwaukee M18 Fuel Tool Mount / Holder

Tool mount will work with most tool types. Currently mounted with Tool attached sideways. Printed in PLA Plus + eSun Fire engine red.

Currently been in the back of a work van doing 140 miles on average a day, motorway, back roads and off road and holding up great.

There are other highly rated versions but the fit wasn't right and too loose where the tool would jump out over a rough bump. This fixes that issue, nice and snug!

https://amzn.eu/d/2h17RkQ

I've printed these out of PLA and Pro PLA with no issues with strength but might want to use PETG or ABS if you want to use these in something like a work truck or other environment that might get really hot in warm weather.

Printed in 0.2mm strength profile and no issues. 

6 walls

25% grid infill.

Feel free to play with settings to preference if this is not going in a rough environment. Print standing up.

Screw hole depths are : 4mm x 22.7mm and 4 x 7mm

4mm Screws advised . Length advised is 30 mm and 15 mm but longer the better where you can :) 

Any questions please through them below and looking forward to your prints.
Will update as suggestions come in.