Potlight Anti-Glare Blind (125 / 135 / 145 mm)

Reduce glare from recessed potlights with this 3D printable blind. Designed to fit most common household recessed potlights with a trim diameter of 125mm, 135mm, or 145mm.

Printing recommendations: PETG is recommended for higher heat resistance, but PLA works fine in most household situations where the potlight trim does not get hot. If the trim does get warm, PETG is preferred to avoid any potential softening or deformation.

Installation notes: To secure the blind, gently pull the potlight trim downward so that the inner edge of the blind is held firmly. If the potlight trim is snug or held firmly by clips, a temporary spacer can be used to create a small gap for easier installation of the blind.

Safety note: When removing the potlight, be careful not to damage the drywall ceiling. If you haven’t done this before, consider watching online tutorials for guidance.

Files included: STL + 3MF. 3MF files provide a tested starting point; adjust settings as needed for your printer and material. Supports are not required; recommended layer height: 0.2mm.