Retracting Keyhook - Kissing Couple - You and I

Tell your partner that you're happy when you're home together through this retracting keyhook. Perfect as a gift for valentines or just a simple way to show your partner some love.

There are two small figures mounted on a lever mechanism that pushes the figures out when the keys are hung and retract when they're taken away. 
You can also stow away the hook fully inside the case. There are two mounting points on the back of the back plate which for screws or nails. 

Every constellation between the figures is possible since they both exist in left and right version. You can freely combine them to fit your couple :)

You can print this model without an AMS if you make the wrinting the same colour as the Cover.

No additional parts needed.

Assembly: 

First put the hooks loosely through the front cover, then lay down the cover on its front side and start assembling from there.

1. Insert the shorter pins as axles for the hooks. 

2. Mount the levers on the pins at the outer edges of the front cover with the elongated hole (e) facing towards the slot for the figures. the flat side (f) of the elongated hole should face down

3. Put a pin through the elongated hole on the lever

4. Mount the corresponding figure with the printed on pin (p) facing towards you.

5. Push the figures all the way to the bottom. Adjust the figures, so that the pins on each figure are in the center of the slot. 

6. Carefully place the mounting plate on the cover with the lower edge first. Just clip it in. 

Now you're ready to mount the keyhooks to the wall.

I hope you and your partner enjoy being home together even more now!

If you like my work please consider liking, boosting and following me.