TRX4M Front Shock Mount Relocate

I was looking for some additional articulation so wanted to angle the shocks, but then I wanted more ground clearance and even more articulation so I upgraded to some Injora 59mm shocks. Honestly it's a pretty sweet setup now with these mounts.

NEW PRINT PROFILE: Added a modified design that allows for full articulation of the shocks. The original design mounted using the existing two holes in the frame, but the servo would hit on the shock mount reducing the amount of shock flex. This new design mounts using the rearward hole and you can either drill a second hole in the frame (drill guide provided in the .3mf file) or you can just use the one frame hole and then add in the middle brace cylinder which should help stiffen everything up when only using only one bolt on each side to mount. The last 2 pictures show both the second hole drilled in the frame and the support brace cylinder installed.

I have similar mounts designed for the rear shocks that you can find here if you need them: https://makerworld.com/en/models/2290699-trx4m-rear-shock-mount-relocate#profileId-2499357

If you're looking for a great wall stand holder for your TRX4M with a spot for your radio: https://makerworld.com/en/models/2102474-trx4m-updated-wall-stand-mount#profileId-2273712

I have a body lift that allows for the body to set higher allowing for larger tires and allowing the body to hinge up: https://makerworld.com/en/models/2292264-trx4m-body-lift-low-profile-bumper-hinged-body#profileId-2501257

I have a replacement for the boring spare tire on the back: https://makerworld.com/en/models/2292550-trx4m-bronco-spare-tire-delete-ladder#profileId-2501594