ESP Parametric Case | Magnetic

Fully Parametric ESP32 / ESP8266 Case

🔧 Features

• Snap-fit
• Customize
  - Board width (mm): 20 - 40
  - Board length (without Antenna) (mm): 40 - 70
  - Board thickness (mm): 0.8 - 2
  - Inner box <-> Board dif (mm): 1.5 to 30
     1.5 => Header Outside
     7.5 => Header Inside
  - Additional box length (mm): 0 - 30
     If your board has an antenna, set it at least to 6mm
  - Additional box width (mm): 0 - 16
  - Show/Hide header holes: 1=Show; 0=Show
  - Create two cable holes at the USB side: 1=Show; 0=Hide (only created, if box <> board dif ≥ 8mm)
  - Create two cable holes at the antenna side: 1=Show; 0=Hide
  - Cable hole diameter (mm): 2 - 6
  - Show/Hide sensor holes: 1=Show; 0=Show (only created, if lengthAdd ≥ 14mm)
• Support:
  - Square or rounded PCB corners
  - micro USB or USB-C
  - Any Pin Count
• Wall Mount 
  - Magnetic: (8x2mm) Just press them into the holes.
  - Screws: Distance 40mm
• Opener

🖨️ Print Settings

• Material: PLA or PETG
• Layer height: 0.2 mm
• Supports: not needed

Change Log

• 2026-01-30 
  - cableHoleAntennaSide did not work (thanks to @nopcode85)
  - USB Hole could disappear at specific size (thanks to @nopcode85)
  - Added Sensor Holes option
  - Allowing additional box length up to 30mm (lengthAdd)

🔗Links

• Digital Caliper:  https://s.click.aliexpress.com/e/_c4kedgf1