Gengar 3D Printed Pokemon

This is a flat layered 3D-printed Gengar wall or desk decoration. It works best as desk decor, shelf display, kids room decoration, or a collectible display piece. Lightweight and colorful, it’s ideal for adding a fun accent to a gaming setup, office desk, or bedroom shelf.

The great part about these models is they only take a couple hours and use less than 100g of total filament. 

Each layer is its own color so there are only five color changes. When changing the colors if you do not have an AMS you can pause the print when each color is finished and change the color. 

It is 4.08mm thick and roughly 9" in height. 

-Initial layer height is .24 and layer heights are .08.

-I use a height range modifier from .24-4.08 at .24 with 15% infill, 3 bottom shell layers and 5 top shell layers. 

-After 4.08 print it at .08 layer heights. 

I print with my aux fan off. If you do not I suggest adding a brim. 

For more Pokemon and other gaming prints check out my profile. 

You do not have to use the exact colors below but it will look better if you do. 

Swap Instructions:
    Start with Black
    At layer #51 (4.24mm) swap to Bambu Dark Blue
    At layer #52 (4.32mm) swap to Bambu Indigo Purple
    At layer #54 (4.48mm) swap to Bambu Lilac Purple
    At layer #56 (4.64mm) swap to Bambu Hot Pink
    At layer #60 (4.96mm) swap to Polymaker Cold White for the rest.