Silencer .177 / .25 cal 1/2" UNF

Silencer with turbulencer and baffles for .177 &.25 air guns.

1/2" UNF thread inset for adjusting the silencer orientation.

"Thread-99.stl" and "Thread-98.stl" is 1% / 2 % smaller in diameter for better fitting. You only need one.

.25 cal Version added but not tested if material is strong enough. So be careful when testing!

Vertical printing orientation with front side down on the bed

Remark:

To achieve even better damping, I drilled holes in the lower part and pressed foam into the chambers. The holes were then sealed with hot glue (see picture of the bottom part).