Sunbow G1 Predaking

PLEASE READ 

This model borrows tech from ToyMakr3D so refer to their website and instructions for their combiners if you need any assistance or idea in assembly. This model was co-designed by "Tigerblade." I helped fine tune parts and settings to get it dialed in and ready for 3MF printing. 

Some of the parts are tight fitting and may need slight shave via a deburrer tool. 

All the colors loaded into the project are the exact colors and filaments I used. 

Every plate is organized and labeled and parts oriented to the best of their print success. 

The leg animal heads print a little janky on the supports so be very careful with support removal. 

The main combiner head slides in for a very tight fit. (filament depending) just get it the depth you would like and glue from the backside of the face. 

The large ball joints for the ankles are scaled to 102% to ensure a snug fit, you may need to use a rubber mallet and carefully pound into each side. (if this becomes too problematic, scale back down to 100%) again filament may vary. 

The backpack and wings will hinder arm articulation so I suggest NOT gluing the backpack on. Pose the arms how you want and place backpack on. Rinse and repeat. 

I have the Decepticon symbols, eyes for animal heads and horns for animal heads all painted in Bambu Studio. If you don't have AMS or just want to reduce print times, feel free to erase all paintings before printing. 

Settings at 15% infill and Gyroid pattern.