P1P P1S Light - Brighter Stock LED

My P1P is located in a glass cabinet and the reflection of the light in the standard position was too bright.

This moves the LED to the front of the case by clipping into 3D Sourcerers front cable tidy.

If you have a PTFE guide that collides with the LED this one by AdamL is confirmed to clear

Diffused

Print 1 of each assembly, clip the Mount&Diffuser piece to the cable tidy then slide the LED strip in with the wire at the left hand side. Finally slide the Shroud over the assembly with the locator pins in each end.

No Diffuser

Print 3 of the clips and push them through the gaps in the cable tidy then slide the LED strip in with the wire out at the left hand side.