P1S Mini Assembly instructions:
Required:
- All printed parts (Including 2 sideplates)
- 10cm long piece of (black) filament
- Superglue
- 6.78x6.40cm Laser cut acrylic
- Sandpaper / file
- Support removers
- Scissors
Assembly:
- Remove all supports – if using my GCODE, use a pin to push a support out of the small circular hole in the door. This is where the filament will act as a hinge
- Put a sideplate on each side of the body in the grooves – no glue required
- Put the acrylic into the door – you may need to sand the acrylic a bit
- Push the door into the front of the printer body
- Slot the filament through the hole on the top so that it goes through the door, and into the bottom of the body. Cut the excess of from the top
- Glue the door handle to the notch on the door
- Slide the toolhead onto the XY rod and glue it to your preferred place, in the channels on the inside of the printer.
Notes:
- I highly recommend using my GCODE as I have fine-tuned the print settings
- I have not tried ‘build plate only’ supports on the body of the printer – use at your own risk. I only included this as it can take 10-ish minutes to remove the supports from inside the printer
- Due to tolerances and measurements, this model is not scalable yet
- EDIT: I have now published an AMS model that is compatible with this one (it can be seen in the cover photos). It can be found here: https://makerworld.com/en/models/2465704-ams-mini-with-filament-spools#profileId-2706664
I would really appreciate if you could like/boost this model as it took a while to design! Please let me know if there are any improvements which can be made
@r1vet
r1vet
