Nintendo Switch & Switch OLED - XXL Travel Box

⚠️ Updated Version Available

A new and improved V2 screwless version of this travel case is now available.

Main improvements:
• No screws required – fully clip-assembled for easier printing and better durability
• Redesigned cartridge slots for more secure game retention over time
• Replaceable lids and clips for easier customization and maintenance
• Reduced hinge stress for improved long-term reliability

If you are printing this case for the first time, I strongly recommend using the new V2 version instead.
This original model remains available for users who specifically prefer the screw-based design.

Link for the new version: https://makerworld.com/fr/models/2795300-switch-case-classic-oled-ultimate-edition#profileId-3108906

🎮 Nintendo Switch / Switch OLED XXL Travel Case

After the success of my XXL case for Switch 2, many people asked for the same concept for the Nintendo Switch (V1) and Switch OLED — so here it is!

This XXL storage & travel box is designed to carry your full setup safely, while keeping everything organized.

🧩 What fits inside?

The large base gives you room for:

• Pro Controller cradle
• Charger
• Dock in station
• Extra Joy-Cons & straps
• Amiibos
• Accessories
• …or even your snack for the trip 😄

The lid includes storage for up to 24 game cartridges.

🖨️ Main print profile (6 plates)

1. Switch + strap holder
2. Lid with Nintendo Switch logo (same lid as my Switch Slim Case, so you can upgrade and save the lid printing time)
3. Main base
4. 2 latches + Switch support retainer
5. Pro Controller cradle
6. Base divider

🎨 Extra lid designs

Other profiles include themed lids: Zelda, Pokémon, Splatoon, and more — pick your favorite!

🔧 Assembly (M3×40 screws ×6)

• Place the lid on the base
• Insert 2 screws into the rear hinges (outside → inside)
• Insert 2 screws in the front latches
• Insert the last 2 screws at the front base hook points
• Add the controller cradle and/or dividers
• Insert the Switch support retainer into the holder
• Place the holder into the base
• Insert the Switch (top first, then clip the bottom)
• Slide straps into their slots
• Close the case — ready to go!

🎮 Pro Controller security

The cradle holds it well, but for extra safety you can add an elastic band:
Attach it to the ring, pass it over the controller, and hook it to the front tab.

⚙️ Printing tips

• Prints great in PLA
• Avoid Silk PLA (weaker layer bonding → hinge break risk)
• For durability: PETG, ABS or ASA recommended
• Minimal supports (mainly the Switch holder) + small brim for latches

👉 Check out my other models:

• Switch Slim Case (V1/OLED)
• Switch 2 Slim & XXL cases
• Slim game cartridge travel case

Enjoy, and take your full Switch setup anywhere! 🚀