Minimal Slanted Laptop Stand

This model consists of two separate stands (DX and RX) designed to support laptops, tablets, or similar devices at an inclination angle of approximately 15°, improving ergonomics and airflow.

The design is minimal and slanted, with no moving parts, focused on stability, simplicity, and a clean desk setup.

Important Printing Notes

This model is prone to warping, therefore several precautions have already been included:
    •    Integrated mouse ears on each stand
    •    One model per build plate is strongly recommended
    •    Reduced print speed during the first part of the print to improve initial adhesion

Printing Recommendations

To further minimize warping, I recommend:
    •    Washing the build plate with dish soap and warm water
    •    Drying it thoroughly before printing
    •    Using standard bed adhesion settings in your slicer

With these precautions, the print worked reliably in my case.
 

If you print this model and find it useful, a boost would be greatly appreciated.