Skelemagmon - UG VR

Skelemagmon - Supertitan 01

A fusion of the Magmadon and Triskeletops, the Skelemagmon from UG VR.

IMPORTANT: The body of this model is NOT easy to remove from it's supports, it is very fragile. 

Getting it perfect is tricky and takes time.

 As it turns out, a walking skeleton isn't very structurally sound. 

YOU WILL NEED CLIPPERS IF YOU WANT TO KEEP THE HORNS AND TAIL IN ONE PIECE! 

It takes effort, but you can free it without breaking if you just take your time.

Even after assembly, several parts are rather fragile, most notably the ribcage, horns and spikes. Please be gentle with this one!

Below in orange are some of the critical regions that are most likely to break under pressure.

Getting it perfect is definitely possible, but at the end of the day, don't worry too hard if you lose a rib or two.

Review the model in the slicer and find the supports and model so you don't clip the wrong parts.

I've angled it so the ribcage prints without supports, which saves quite a bit of time and pain.

Please keep the parts in their current orientations; they might require extra supports, but they are placed for optimal printing of the sockets.

I used the clippers shown below.

Use PETG or ABS for this model, PLA will cause the joints to loosen in a few days.

Clippers are required for the main body. The supports on the rest off them should separate easily.

Again, this does take some time and effort to complete. Please go slowly and be careful for good results.