Mario Mystery Box Raspberry Pi 4 Case

Wow! your friends with this unique Raspberry Pi Case, designed for RPI 4

IMPORTANT: There is a panel that is 120mm x 126mm, this is the side panel and you will need to print this one twice.

Features

• Very solid and sturdy design.
• Easy to print and no need for an AMS as the Question Marks(white) are printed separately.
• Easy assembly with the use of 16x m3.5 x 5 screws.
• Designed to allow all connections from the rear.
• Future version will have an IO Pin slot in the rear and further upgrades.

This is version 1. More releases will come in the near future with upgrades such as legs (case already has the slots for them) along with an IO Port slot in the rear.

I had supports on for the panels due to the question mark on them being recessed. Your surface from the supports should not matter so much if it comes out bad because the white question marks will cover any blemishes completed. So do not panic, I left on default support, so if you have a good suggestion that works well for you, please let me know in the comments! =)

Suggestions and feedback are always welcome! I am new to the 3D Design world and always learning new best practices in design and always open to criticism to improve my designs.

Reminder, this is just version 1, please let me know if there's anything you think might make the case even better! The reason for I went with this size design (bigger than the traditional Pi case design) is so that there's room inside the case for the cables on the side such as mini HDMI and USB C to have enough room to rout to the rear, without any concern of flexing the cords much at all.

Wanna buy me a coffee to help fuel my teaching days and help me pop out new designs?
https://paypal.me/kevinwatts029?country.x=US&locale.x=en_US

Much appreciated for any and all support!