Quick Release Poop Bucket

A mini version of this model can be found here

• Satisfying snappy quick-release mounting
• High poop capacity
• P1S or X1C 
  • Should fit P2S as well, but haven't confirmed. Message me if you want a quick test print.
• No hardware required
• Uses only 50g of filament
• Won't rattle or fall off
• Doesn't interfere with spool holder
• I think it looks pretty cool

     

 

I wasn't able to find a poop bucket that checked all my boxes so I decided to take a stab at making my own. To install this, use a 2mm hex key to remove the lower screw from your printer's poop shoot and re-use the screw to secure the included hook/knob to the same screw hole. I recommend tightening with the short end of the hex key to avoid overtightening, it doesn't take much to get a secure hold.

 

** V2 makes some cosmetic improvements and slight geometry changes. Approximately 1 in 10 poops were taking an errant bounce and overshooting the bucket. That should be resolved, as well as a deeper counterbore to give the mounting screw more thread engagement.

 

Boost MeFusion crashed many many times in the process of modeling this, if it helps you out please consider boosting this post!