Big playstation led sign ,A1mini compatible , 65cm

Print plate 1-4 ,then using plate 5 connectors line everything up and screw in small 3x10mm screws or similar .
Start from the triangle ,carefully add the led strip , put the wires through the back then to the next letter , cut the wire and solder the next strip (i used a metal sheet to protect the plastic from solder.
Repeat for all the letters . 
Be careful when adding the led strip or running the wires that they are about 1.5mm at least from the outside or inside edges , cause that will cause the diffuser not to fit in properly . If this happens you can cut some areas of the diffusers , so they fit .
For the loose wires and places where the led strip bends you can add a drop of hot glue .
Plate 6-9 are the diffusers .
Plate 10 - Rear wire covers and spacers for screwing in to the wall .
You don't need to use all of the bigger holes to mount it to the wall.
After screwing to the wall insert the diffusers . If they are too loose add a few drops of ca glue .
I used ws2812b led strip with bt20 usb led controller .
Happy printing .