February 16, 2026
Description
Scatter terrain: Altar for D&D or any other tabletop adventure.
Prints with minimal supports (just at the front of the altar. Sometimes, auto supports are being generated under the book, but you can just leave them there ;)
Printed with SUNLU PLA+ on eSUN PLA+ Filament profile. For this one, I turned ironing on because of the stairs and altar surface.
Layer height: 0.08 mm
Walls: Arachne
Ironing: Top Surfaces
Top/Bottom shells: 4/4
Infill: 20% (change based on your preference, model is really thick)
Speed (Support): 100mm/s (A little bit slowe, I had some adhesion problems with my supports)
Supports: tree(auto), Organic
Initial layer density: 80%
Top/Bottom Z distance: 0.24/0.22 mm
License:
MakerWorld Exclusive License
Blichew
