Anatomical Broken Heart Magnet

This small magnet about 6cm height. Uses just 9g of plastic, only 3% infill. 
In Print profile cuts are done for 8x3mm magnets, if you want to change - just change the size of the cylinder modificator or it's position (I think it should hold good with single magnet as well).  I inserted magnets without the glue, just aligned them and pressed against surface - after click they went inside. 

Heart is printed vertically to avoid layers on the front, as this is display piece - I prefer to have layers on top instead of front. 

This one is broken heart, there is option with normal heart as well. 

This small accessory is part of Heartbroken collection.