Dantoy scooter wall mount

I was getting tired of constantly tripping over my daughter’s ride-on toys, so I started designing and printing wall mounts to free up some floor space.

The red and blue scooter from Dantoy is something many Danish children grow up with, so I hope this mount can help others organize their sheds and garages more efficiently.

Print time = 1h 4m

Filament use = 49g

Print Settings

For optimal strength, this mount should be printed with reinforced wall settings.

Recommended settings:

• Layer height: 0.2 mm
• Wall/perimeter layers: 5
• Top layers: 7
• Bottom layers: 7
• Infill: 30%

Material: PETG is recommended to ensure sufficient strength and durability.

With these settings, the bracket is more than strong enough to support a standard small Dantoy scooter.

Hardware

Use mounting hardware appropriate for your wall type (e.g., wood screws, masonry anchors, etc.).

Safety

This mount is designed to hold one Dantoy scooter only and is not intended for any other purpose.

Use at your own risk. Ensure proper and secure wall mounting before use.

Feedback

Suggestions for improvements are very welcome.