Wire-Rack-Shelves - 14", 16" and 18"

Clip-on 13-½" X 6" tray that attaches to 1" post of 14" deep wire shelving.   To install, clip shelf onto 1" post; slide up and down until it click into post grooves. Locks in place with retainer clips (do not glue).    Clips can be removed for repositioning. 

• On centers of 1" post on wire shelving is 12-5/8".   There's some flex on my support bracket clips - plus / minus 1/8".  

  Should fit  posts on centers between 12-½-12-¾" 

• Assembly - there a four hexagonal posts to locate tray on support bracket for glueing. 
• All my print profiles are in PLA, 2X wall and minimal infill for quick prints.    Parts has held up for me.  Adjust as needed. 

• 03/03/2026  - Print split into 4pcs + clips so it now fits X1,P1,P2 & A1 printers.   Two print profiles added.   One specifically for the A1 Mini.

  Once glued properly, I think is perfectly serviceable. 

• 03/04/2026 - Added  print profile for 16" wide version.
• 03/05/2026 - Added  print profile for 18" wide version.
• 04/23/2026 - Added retainer clip to 18" wide version.  Was missing.

Please give me a boost if you found this print useful and post comments on the good, the bad and ugly.  

Thanks!