Havok 6.4 MK-X

Finally, the updated version of the Havok. 

Lots of changes on this model. Most noticeable is the exterior styling. The big change was moving one of the mount points (right side) up closer to the top of the device. I have been printing in more rigid material and found the seal was not great with the previous model. 

All the components will work with the previous generation. As long as you have the universal mount board, you can just disassemble your device and reassemble it in the new body. If you don't have the universal mount board, you will need to swap your Rak to the new mount.

2 Plated are in the file. One for the device and the other for the TPU gaskets. 

Note: The new antenna gaskets I didn't write about in the assembly guide (I forgot), these simply slide over the SAM antenna slots on the outside of the device. 

I have been printing these with Siraya Tech Fibreheart PET-GF from Amazon  (https://amzn.to/4aZ4ujN). This filament is a bit of a challenge to get right with an A1, but looks and feels great when you get it right. 

Updated assembly guide attached. Comment or message me with any questions. 

If you print this and like it please tag me on instagram @xblockdesign