Bring back the golden era of full-service stations, porcelain signs, and real American garages.
This vintage-style round lightbox is inspired by classic illuminated service station signs and designed to mount perpendicular to the wall — just like the originals. Whether you're building a garage setup, bar corner, shop space, or man cave, this one makes a statement.
This model is fully 3D printable and designed for easy assembly and clean wiring.
Features:
• 224 mm diameter
• 50 mm total thickness
• Double-sided design (visible from both directions)
• Includes wall-mount brackets
• Hollow bracket arms for hidden LED wire routing
• Designed for LED strip lighting
• Clean, even light diffusion
Installation:
- The included mounting brackets are hollow, allowing you to run your LED wiring directly through the arm for a clean, professional install — no exposed wires hanging down the wall.
- Super easy to install by using the hole jig found on plate 4.
- Just use the jig to mark your holes.
- Mount the brackets using drywall screws or similar with the wiring tunnel facing up for top bracket and down for bottom bracket. (I found it easier to put my wire through before tightening the screws against the wall)
- Then slide the lightbox frame onto the mounts and push till it clicks into place.
- Next, just remove the adhesive backing strip and route your lights around the inside of the frame as many times as you would like.
- The design is intended to be used with your own LED light kit. The example shown was lit using a Cobb 5v wired strip like found here on amazon. https://a.co/d/0gaqt958
Printing Notes
- Printed in PLA for the example shown
- PETG or ABS will work as well if you prefer added durability.
Whether you’re lighting up your garage, bar, shop, or whiskey wall — this piece brings that old-school Americana glow.
FILAMENTS USED ON MY EXAMPLE:
ChopperOriginals
