March 7, 2026
Description
I couldn't find a skull wine cork so decided to make one myself. Based this off an old wine cork I had at my house.
It will not seal without the o rings, but it can be decorative with out them.
The O-rings i used are 14OD 1.5mm
Note, the seal will also not be tight. Might be tighter if scaled and used TPU.
I used Silk PLA.
NOTE:
In the 3mf I added an extra column in the middle to make it stronger where the skull sits on the cork.
I used 3 loops and 15% Gyroid infill. Recommend to not choose support critical areas only. The print will most likely fail.
Printed with .20 layer height.
License:
CC0