Comma 4 Side Sliding Mount

Want to mount your Comma higher up on the windshield but still be able to take it off? 
Have a 3D printer at home and don't want to pay someone else for their 3D printed mount?

This simple design uses the stock mounting position on a comma 4, then adds a second piece to the backside which allows for you to slide it on and off sideways, rather than towards your roof. 

 

I strongly recommend you print this in ABS, ABS-GF, or a form of nylon. PLA will deform on your windshield. PETG will likely deform over time. Considering your comma relies on a fixed position on your windshield, it's best not to tempt fate with a cheaper filament. 

 

Be sure to mount this with 3M VHB tape so it cannot fall off during summer sun.

 

Boost MeLike the print? A boost would go a long way to help me out! I appreciate you!