Phone Holder "Exagon" V2

Hi, I would like to introduce you to my New Phone Stand Exagon V2

This is a rivisited version of the first model that has been highly appreciated by users.

I hope you like it. Good Print !

If you have any problems with adhesion you can try turning off aux fan when printing PLA

You can find the first version here
https://makerworld.com/en/models/193049#profileId-214820

You can find the raised version (allow charging) here

https://makerworld.com/en/models/397838#profileId-299273

If you like my project consider supporting my job with a boost. Thank you !

Attention A1 series :

In some cases only on the A1 series someone has reported problems. 
I tried various prints on my A1 mini without problems, like other users, but someone has reported problems.
I don't understand what the problem could be generated (firmware? slicer? bed slinger? air flows?)
I don't think it's a profile problem but I can suggest if you want to try to use a standard profile 0.2