Kratos God of War Hueforge

Kratos from God of War Hueforge. 

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 160x240mm in sizeYou may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 2.24mm and the Actual Thickness is 2.16mm
   #080a0d PLA PolyLite Black  Transmission Distance: 0.3
   #c00d1e PLA BambuLab Basic Red  Transmission Distance: 4
   #545454 PLA BambuLab Basic Dark Gray  Transmission Distance: 0.6
   #ffffff PLA BambuLab Basic Jade White  Transmission Distance: 5
   #000000 PLA BambuLab Basic Black  Transmission Distance: 0.6
This print uses 5 unique filaments
Swap Instructions:
   Start with Black
   At layer #11 (0.96mm) swap to Red
   At layer #16 (1.36mm) swap to Dark GrayBorder Only Colors from here until the end.
   At layer #19 (1.6mm) swap to Jade WhiteThis slider is set higher than the mesh depth.  It is not affecting your final mesh.  Consider removing it.
   At layer #29 (2.4mm) swap to Black for the res